File information: | |
File name: | Service Bulletin OST-US007.PDF [preview Service Bulletin OST-US007] |
Size: | 1331 kB |
Extension: | |
Mfg: | DENON |
Model: | Service Bulletin OST-US007 🔎 |
Original: | Service Bulletin OST-US007 🔎 |
Descr: | DENON AV Surround Receiver & Amplifier AV Surround Receiver & Amplifier Denon - AVR-5805 & AVC-A1XV Service Bulletin OST-US007.PDF |
Group: | Electronics > Other |
Uploaded: | 27-03-2022 |
User: | Anonymous |
Multipart: | No multipart |
Information about the files in archive: | ||
Decompress result: | OK | |
Extracted files: | 1 | |
File name Service Bulletin OST-US007.PDF 100 Corporate Drive Mahwah, NJ 07430 Service Bulletin No. : OST-US007 Date: April 26, 2007 _____________________________________________________________ Model: AVR-5805 Subject: Disassembly Instructions Symptom: Disassembly instructions for the AVR-5805 DAC Unit and Digital Unit. Solution: See the following pages for details: ______________________________________________________________________________________ CONFIDENTIALITY NOTICE: The information contained in this document is intended for the exclusive use by DENON Authorized Service Centers and their employees. This document may contain information that is privileged, confidential and may be protected from disclosure under applicable laws and terms of the DENON Service Agreement. Any distribution, disclosure, dissemination or copying of this document and the information it contains is prohibited. No responsibility will be accepted by DENON for any damage, injury or loss resulting from the misuse of the information contained in this document. Instruction for removal of DIGITAL UNIT ASSY and DAC UNIT ASSY (1) Remove screws, detach the BOTTOM COVER (Not shown in the figure) (2) Remove 6 screws from BACK PANEL, and remove FFCs and cables (3) Remove 4 Card holders, then detach the Rear Plate/Ethernet/IEEE1394 assy unit. Remove the FFCs and cables Remove 4 Card holders Remove 6 screws from BACK PANEL (4) Remove FFCs and Cables (5) Remove 2 screws and incline the PWB. Remove 2 screws Incline the PWB Remove the FFCs and Cables (6) Remove the screw. (7) Remove each side board to board connector carefully. Remove the screw (8) Insert the finger in the space, and lift the PWB gradually. (Remove the B to B connectors in the reverse side of the PWB) Lift the PWB gradually Remove the B to B connectors in the reverse side of the PWB (9) Remove the Cables and detach the Digital unit assy. Remove the Cables (10) Remove each side board to board connector carefully. And detach the DAC unit assy. Instruction for re-assemble DIGITAL UNIT ASSY and DAC UNIT ASSY (11) Install the DAC unit assy and insert each side board to board connector. (Insert the hand in the space on both sides, and push the PWB.) (11) Install the Digital unit assy and insert the cables. (12) Insert right side B to B connector. Insert the B to B |
Date | User | Rating | Comment |